Filter
Top Products
18
|
English
General features
Display Type F
In Standby mode
G-Analyzer Calibration setup
G-Analyzer requires calibration for horizontal
acceleration and braking.
⁄
• To ensure accurate calibration, go through the following
steps at a level place where you can move the vehicle
straight ahead.
1 Park the vehicle in a horizontal location
2 Enter G-Analyzer Calibration setup mode
Using the Control knob, select "DISP" > "GMA"
> "CAL".
For the operation method, refer to <Function
Control mode> (page 10).
"G-CALIBRATION" is displayed.
3 Start Calibration of horizontal direction
Press the Control knob.
Once "Move Forward" appears on the display, the
vehicle must be advanced.
4 Start Calibration of straight direction
Start moving the vehicle ahead.
Calibration of straight direction automatically starts.
When the Calibration is finished, "Calibration OK" is
displayed.
⁄
• If you fail to complete the calibration, "No Calibration" is
displayed. In such a case, repeat steps 1 through 4.
5 Exit G-Analyzer Calibration setup mode
Press the [FNC] button.
Display Type F
In Standby mode
G-Analyzer vehicle weight setup
Enter vehicle weight to calculate horsepower.
1 Enter G-Analyzer vehicle weight setup mode
Using the Control knob, select "DISP" > "GMA" >
"HP SET" > "WEIGHT".
For the operation method, refer to <Function
Control mode> (page 10).
"WEIGHT INPUT" is displayed.
2 Select the weight numbers
Turn the Control knob.
⁄
• The weight input range is between 1000-9999 lbs.
3 Select the digits to enter
Push the Control knob towards right or left.
4 Repeat steps 2 and 3, and complete the weight
input.
5 Exit G-Analyzer vehicle wight setup mode
Press the Control knob.
Display Type F
In Standby mode
G-Analyzer vehicle class setup
Enter vehicle class to calculate horsepower.
1 Enter G-Analyzer vehicle class setup mode
Using the Control knob, select "DISP" > "GMA" >
"HP SET" > "CLASS".
For the operation method, refer to <Function
Control mode> (page 10).
"CLASS SELECT" is displayed.
2 Select vehicle class
Turn the Control knob.
Each time you push the knob, the vehicle class
alternates between the modes shown in the table
below.
Display
"Mid Size"
"Full Size"
"SUV"
"Van/ Mini-Van"
"Pickup Truck"
"Sporty"
"Compact"
3 Exit G-Analyzer vehicle class setup mode
Press the Control knob.