Filter
Top Products
English
|
15
Display Type F
G-Analyzer display Selection
Changing the G-Analyzer display.
⁄
• Before alternating G-Analyzer display, you are required to
setup <G-Counter Level seting> (page 17), <G-Analyzer
Calibration setup> (page 18), <G-Analyzer vehicle weight
setup> (page 18) and <G-Analyzer vehicle class setup>
(page 18).
1 Enter G-Analyzer display selection mode
Using the Control knob, select "DISP" >
"GMENU".
For the operation method, refer to <Function
Control mode> (page 10).
2 Select the G-Analyzer display
Turn the Control knob.
Select from the following displays.
G-Force Sensor display
G- Graphic display
1 – 2
Downloaded G-
Graphic*
G-Meter display
(Graphic)
G-Meter display
(Text)
G-Counter display
* G-Graphic can be switched to customized pictures. Refer
to <Picture downloading> (page 41).
⁄
• G-Graphic display
Displays the condition of G in horizontal direction
(e.g; when turning the curve) by the graphic.
• G-Meter display (Graphic)
Displays the maximum value of acceleration G, right
direction G, and left direction G by the numerical value.
• G-Meter display (Text)
The maximum value of acceleration G, right direction G,
and left direction G is displayed by the numerical value.
The value of G is only the reference, so is different from
the actual value.
• G-Counter display
Adds the point of the acceleration level. The point is
determined after a lapse of 1 hr drive or at power off
(ACC Off), and then it will be displayed by the graph.
Furthermore, the G-Counter displays the average of the
past data by the line. (The scale of graph is determined
along with the largest point among the past 10 data.)
• The value of G-Meter display and G-Counter display can
be reset by <G-Analyzer Reset> (page 17).
3 Exit G-Analyzer display selection mode
Press the Control knob.