Filter
Top Products
English
— 38 —
Installation
Removing the hard rubber frame
■
When the upper level is removed, remove the lower two
locations.
3
The frame can be removed from the bottom side in the same
manner.
NOTE
Refer to the section “Theft deterrent faceplate (P. 12)” and
then remove the faceplate.
Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Push upward the frame and pull it forward as shown in the
figure.
2
1
Accessory6
Removing the Unit
■
Push upward the removal
tool toward the top, and
pull out the unit halfway
whilst pressing towards the
inside.
4
Pull the unit all the way out
with your hands, being
careful not to drop it.
5
Be careful to avoid injury from the catch pins on the removal
tool.
2CAUTION
Catch facing up
Refer to the section “Removing the hard rubber frame (P. 38)”
and then remove the hard rubber frame.
Remove the Hex-head screw with integral washer (M4×8) on
the back panel.
Insert the two removal tools deeply into the slots on each
side, as shown.
3
2
1
Accessory3
Removal tool
Catch
Lock
Accessory3
Removal tool
KDC-X615_U.S_K_r6 00.12.26 3:45 PM Page 38