Filter
Top Products
English
— 36 —
Connecting Wires to Terminals
ANT.
CONT.
ILLUMI
EXT.CONT.
P.CONT
+
+
+
+
FRONT • L
FRONT • R
REAR • L
REAR • R
–
+
FRONTREAR
When only two speakers are being connected to the
system, connect the connectors either to both the
front output terminals or to both the rear output
terminals (do not mix front and rear). For example, if
you connect the + connector of the left speaker to a
front output terminal, do not connect the - connector
to a rear output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
2WARNING
FM/AM antenna input
Rear left output (White)
Rear right output (Red)
Fuse (10A)
KENWOOD disc changer
/ DAB control input /
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Ignition key
switch
Car fuse
box
(Main fuse)
ACC
Car fuse box
Battery
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
Front left output (White)
Front right output (Red)
/Non-fading left output
(KDC-X615 only)
/Non-fading right output
(KDC-X615 only)
To connect the Disc changer or
DAB unit, consult each manual.
NOTE
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
When using the optional power amplifier, connect
to its power control terminal.
To car light control switch
External amplifier control wire
(Pink / Black) (KDC-X615 only)
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
Display Data Output Jack
Outputs data representing the
unit's current state, causing it
to appear in the external
display.To connect to this jack,
a converting adapter (optional)
is necessary. (KDC-X615/6015
only)
KDC-X615_U.S_K_r6 00.12.26 3:45 PM Page 36