Filter
Top Products
Function of the KDC-X615/KDC-6015
You can switch the color of the button illumination between
green and red.
Display and setting:
"Color Green/COL GRN" : The color of the illumination is green.
"Color Red/COL RED" : The color of the illumination is red.
Selectable Illumination
"CODE" appears in the display, you can start inputting the
code.
Press the Preset button and input the security code again.
Press the DISP button again for at least three seconds.
"APPROVED" will appear in the display, with the security code
function turning on. From this point on, if the unit is
disconnected from the battery, the security code must be
entered the first time that the unit's power is turned on.
"ENTER" and "CODE" will appear in the display, asking you to
input the code.
If you input an incorrect security code, the code setting mode
will be canceled automatically. Follow the steps from 5 to 9
above again.
If you press the RESET button or remove the battery:
The first time you turn the unit on again, "CODE" will appear in
the display, asking you to input the security code.
Repeat steps 8 and 9 above, and input the security code.
You can start operating the unit again when "APPROVED"
appears in the display.
If you enter the incorrect code, the power will turn off. Enter
the correct code to turn the unit on.
NOTE
9
8
Once the security code function has been activated,
"Security/SECURITY" disappears from the MENU system. Note
that it will no longer be possible to cancel this function
afterwards.
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
Select the four digits to use in your security code.
The four-digit security code is very important, as you will need it
to turn the unit on again when the code security function is on.
Choose the number carefully and do not forget it (write it down
and keep it separately in a safe place).
Press the MENU button for at least one second.
"MENU" is displayed and the menu mode is turned on.
Keep pressing the FM button until the "Security/SECURITY"
appears in the display.
Press the AM button to search in the other direction.
Press either the 4 or ¢ button for at least two seconds.
"ENTER" will appear in the display for one second, indicating
the code setting mode has been entered. When "CODE"
appears in the display, you can start inputting the code.
Press the preset button and enter the security code that you
have selected in step 2.
Example: Use "3510" as the security code.
Press the DISP button for at least three seconds.
The security code will be set.
"RE-ENTER" will appear in the display for one second, asking
you to enter the code once again for confirmation. When
7
Step Button to press
# Times
pressed
Display
1
#1 4
3
6#2
2
#3 2
4
#4 1
“3”
“5”
“1”
“0”
6
5
4
3
NOTE
2
1
— 29 —
KDC-X615_U.S_K_r6 00.12.26 3:45 PM Page 29