Filter
Top Products
56
KR-V9090/8090 (En/T)
Preparations
Operations
Other
Memory back up function
Please note that the following items will be deleted from
the unit's memory if the power cord is disconnected from
the AC outlet or the main power switch is turned off for
approximately 3 days.
• Power mode.
• Settings made (like SURROUND SET UP).
• Input selector settings.
• Volume level.
• Broadcast band.
• Frequency setting.
• Preset stations.
Remote control unit
Cause
• The batteries are nearing exhaustion.
• Subwoofer is OFF.
• No preset codes registered at for the respec-
tive input(s).
• The remote control is set to a different opera-
tion mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source compo-
nent.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
• The microprocessor of the remote control
malfunctions.
Remedy
• Replace with new batteries to preserve the
currently registered setup information.#
• Turn the subwoofer ON. $
• Register a preset code or Non-IR code at the
respective input(s). fi
• Press VIDEO, AUDIO, or TV to select the
approriate operation mode.
• Replace with new batteries. If the backup is
exhasted before you can replace the batter-
ies, redo the setup procedure. #fi
• Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”. 8
• Place software in the source component you
want to play.
• Wait until recording has completed.
• Press the VIDEO, AUDIO, or TV key to activate
the operation mode for the component you
want to control before operation. ‡
• Reset the microprocessor. w
Symptom
The backlight flashes five times during nor-
mal operation.
Subwoofer volume cannot be adjusted.
Certain inputs cannot be selected using
the remote control.
Remote control operation is not possible.
In case of difficulty
Do not use contact cleaning agents because they could cause a malfunction. Be specifically careful against using contact cleaning agents
containing oil, since they may deform the plastic components.
Note
Note