Kenwood KR-V9090 Stereo Receiver User Manual


 
Preparations
14
KR-V9090/8090 (En/T)
Operations
Other
To enhance the surround modes, various parameters can be
set up to accomodate the speaker system used and the
environment of the listening room. The following procedure
let you set the parameters of the surround modes (DOLBY
PRO LOGIC, DOLBY 3 STEREO and DSP).
Once the settings have been done, it is held in memory so
readjustment is not necessary even after the mode has been
changed.
Recommended speaker installation
It is recommended that the surround speakers are installed straight
to the left and right of the listening position or slightly behind, at a
height of about 1 meter higher than the listener’s ears. Each surround
speaker should be installed so that the longer sides are horizontal.
Preparing for surround sound
Surround setup
1
Select the Dolby Pro Logic surround mode.
2
Select the CENTER MODE.
3
Turn on the SUBWOOFER.
1 Press to select SUB ON (OFF).
2 Use the TUNING/SKIP +/– keys on the
remote to select "ON" (or "OFF" if you did
not connect a subwoofer).
CENTER MODE
When you select PRO LOGIC, each press of the CENTER MODE
key switches the center mode as follows:
1 "NORMAL" :When using a standard (small) center
speaker.
2 "WIDE BAND" :When using a full range (large) center
speaker.
3 "PHANTOM" :When not using a center speaker.
SETUP
TUNING/SKIP
LORPOGIC
SURROUND
Lights
When DOLBY PRO LOGIC is selected
•The following adjustments (center mode, test tone, etc.) are common
for all surround modes, including DSP. You do not need to make
separate adjustments for each sound mode.
OBUsN
SURROUND
Display when the subwoofer setting is selected
•If you did not connect a subwoofer, select "SUB OFF".
PRO LOGIC