Kenwood KR-V9090 Stereo Receiver User Manual


 
18
Operations
KR-V9090/8090 (En/T)
1
Turn on the receiver.
Keys or controls used in this operation.
Listening to a source component
A ON :Sound from the speakers connected to the SPEAK-
ERS A terminals on the rear panel.
B ON :Sound from the speakers connected to the SPEAK-
ERS B terminals on the rear panel.
A+B ON :Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all
playback modes.
•When both SPEAKERS A and B are ON, activating a surround mode
turns SPEAKERS B OFF automatically.
2
3
The indicator for the speakers you want to use should be lit.
5
4
Decrease volume Increase volume
Select a speaker system.
Select the source you desire.
Adjust the volume.
Start playback from the selected source.
Preparations
•Turn on the power to the related compo-
nents.
•Set the POWER key to the ON position.
Normal playback
A
SP.
PHONO
B
A
B
AUDIO
SHIFTMACRO
TVVIDEO
GUIDEREC
MUTE
VOLUMETUNING/SKIP
THEME FAVMENU
FUNCTION
SHIFT
SETUP
INFO ALT AUDTV/SAT/VID
REPEAT RANDOM+100
DISPLAY
ENT+10
LISTEN
MODE
SOUNDSUBWOOFER
564
231
897
0
8
7
6
BAND
P. CALL P. CALL
PHONES
1234567890
STANDBY
MUTE
LEVEL
INDICATOR
DIRECTMEMORY
ABSPEAKERS
AUTO
CENTER MODETUNING BASS TREBLEBAND
LEVEL CONTROL
PRO LOGIC 3 STEREO
STEREO DSP
LOUDNESSSOURCE DIRECT
DIMMER
INPUT SELECTOR VOLUME CONTROL
VIDEO
AUDIOVIDEO SURROUND RECEIVER KR-V9090
ON/STANDBY
DOWN UP
AV AUX
L
-
AUDIO
-
R
MUTE
TA/NEWS/INFO. PTY DISPLAY
+10/
PTY SEARCH
POWER
-ONOFF
TRAITR
thermally reactive advanced instantaneous transistor
POWER
POWER
-ON OFF
ON/STANDBY
SPEAKERSA
B
INPUT SELECTOR
VOLUME CONTROL
DOWN
UP
The input sources change as shown below:
*Once setup codes are registered in the remote control, the input name
display changes according to the name of the registered component.
Example: if you register a VCR at the VIDEO 1 jacks, "VCR1" appears
instead of "VIDEO 1".
•When using the remote control after initial setup, any inputs that have
not been registered with a setup code are deleted from the cyclic list
(except for the "AV AUX" VIDEO input).
•The INPUT SELECTOR on the front panel of the receiver always cycles
through all inputs.
1 TUNER (Frequency display)
2 "PHONO"("PHONO"*)
3 "VIDEO1" ("SAT"*)
4 "VIDEO2" ("LD"*)
5 "VIDEO3" ("VCR"*)
6 "AV AUX"
7 "CD" ("CD"*)
8 "TAPE/MD" ("TAPE"*)
A
VOL -6) dB
A
SP.
Volume display