Filter
Top Products
English
– 10 –
Tuning In a Station
1 Press TUNER/BAND to select tuner mode.
The unit automatically turns on, and tunes in the last
station tuned in (either FM or AM).
2 Press TUNER/BAND to select
the band, FM or AM.
Each time you press the button, the band
selection alternates between FM and
AM.
3 Press and hold 4 or ¢
until “SEARCH” appears, then
release the button.
The unit starts searching for stations.
When a station of sufficient signal strength is tuned in,
searching stops and the TUNED indicator lights up on the
display.
If a program is broadcast in stereo, the STEREO indicator
lights up.
To stop searching, press 4 or ¢.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
To improve the FM reception
When an FM stereo broadcast is hard to receive
or noisy, press FM MODE/VOCAL to switch
to the monaural reception. The STEREO
indicator disappears from the display.
To restore the stereo reception, press FM MODE/VOCAL
again so that the STEREO indicator lights up.
To change FM/AM tuning interval
The unit’s default tuning interval is 50 kHz/step for FM
reception and 9 kHz/step for AM. You can change this setting
when using the unit in an area where the frequency allocation
is 100 kHz/step for FM stations and 10 kHz/step for AM
stations.
1 Unplug the AC power cord.
2 Press and hold 3/8 and VOLUME – on the unit
simultaneously.
3 Plug in the AC power cord.
4 Release the buttons.
To switch the tuning interval back to 50 kHz/step (FM)
and 9 kHz/step (AM), follow the same procedure above
except in step 2 where you press and hold 8/2 and
VOLUME + simultaneously.
Presetting Stations
You can preset 20 FM and 10 AM stations.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1 Tune in the station you want to preset.
• See “Tuning in a Station” on the left.
2 Press PROGRAM.
The PRESET indicator and the current
preset number start blinking on the display.
3 If you want to change the
preset number, press 8/2 or
3/8 repeatedly until the
desired preset number appears.
• Alternatively, use the number buttons on the remote
control.
To select preset number 5, press 5.
To select preset number 12, press +10 and then 2.
To select preset number 20, press +10, +10 and then 0.
4 Press PROGRAM again to
store the radio station.
“STORED” scrolls through briefly.
The PRESET indicator lights up steadily.
5 To preset more stations, repeat the steps
above, allocating a different preset number to
each station.
When a new station is stored
The station previously memorized with the same preset
number is erased. (The frequency of the new station replaces
the previous frequency in memory.)
Listening to FM and AM Broadcasts
Continued
TUNER
BAND
SEARCH/TUNING
FM MODE
/VOCAL
PROGRAM
DIRECTION PLAY/PAUSE
PRESET
PROGRAM