Filter
Top Products
English
– 8 –
Common Operations
Turning On or Off the Unit
To turn on the unit
Press STANDBY/ON on the
unit or remote control.
The unit turns on with the last
source selection remaining valid.
To turn off the unit (on stanby)
Press STANDBY/ON on the unit or remote control.
“BYE BYE” scrolls through briefly and the clock time
appears if the clock is already set.
Setting the Clock
Before operating the unit any further, first set the built-in
clock.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1 While the unit is on, press and
hold PROGRAM until “24” or
“12” HOUR starts blinking.
• When the unit is in standby mode, press PROGRAM once.
2 Press 4 or ¢ to select 12-
or 24-hour mode, then press
PROGRAM.
The hour indication starts blinking.
3 Press 4 or ¢ to set the
hour then press PROGRAM.
The minute indication starts blinking.
4 Press 4 or ¢ to set the minute, then
press PROGRAM to store the setting.
The clock starts working.
To change the hour or minute indication rapidly in steps 3
and 4, press and hold 4 or ¢.
To check the clock time while the unit is on
Press DISPLAY.
The clock time is displayed until you press any
key.
• In 12-hour mode, “AM 12:00” indicates midnight and “PM
12:00” indicates noon.
To correct the clock time
Carry out steps 1 to 4 above.
On clock resetting
If a power failure occurred or the AC power cord is
disconnected, the clock is reset to “0:00” (flashing). In such a
case you need to set the clock again.
Adjusting the Volume
• You can adjust the volume only while the unit is turned on.
Press VOLUME + or VOLUME – to
increase or decrease the volume level.
The volume can be adjusted in 33 steps
between “VOL MIN” (minimum) and
“VOL MAX” (maximum).
To increase or decrease the volume level rapidly, press and
hold VOLUME + or VOLUME –.
To turn off the sound temporarily
Press MUTING on the remote control.
The source name and muting indication
scroll through the display, and playback
continues without sound.
To restore the sound, press MUTING
again or increase or decrease the volume
level.
DO NOT turn off the unit (on standby) with the volume
set to an extremely high level; otherwise, a sudden blast
of sound can damage your hearing and/or the speakers
when you turn on the unit or start playing any source
next time.
Continued
STANDBY
/ON
PROGRAM
SEARCH/TUNING
PROGRAM
DISPLAY
VOLUME
MUTING
or
STANDBY/ON