Filter
Top Products
15
Using the remote control
Putting batteries in the remote control
Before using the remote control, put in two supplied batteries first.
1 On the back of the remote control, remove the battery cover.
2 Insert batteries.
• Make sure to match the polarity: (+) to (+) and (–) to (–).
3 Replace the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two R6S (SUM-3)/AA (15F) type dry-
cell batteries.
CAUTION:
Follow these precautions to avoid leaking or cracking batteries:
• Place batteries in the remote control so they match the polarity: (+) to (+) and (–) to (–).
• Use the correct type of batteries. Batteries that look similar may differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
Operating the system using the remote control
Aim the remote control directly at the remote sensor on the center unit. The effective distance between the remote control and
the remote sensor on the center unit is about 7 m.
• You can also operate other components using the remote control.
– To operate your TV, see page 16.
– To operate your VCR, see page 64.
To control other components, aim the remote control directly at the remote sensor on each target component.
Refer also to their instruction manuals.
• To operate the remote control properly, do not hide the remote sensor by placing any obstruction.
12
3
STANDBY
COMPACT
SUPER VIDEO
DIGITAL• EX
PRO LOGIC
DVD DIGITAL CINEMA SYSTEM
RGB
PHONES
SOURCE
− VOLUME +
Remote sensor
EN1-16.TH-A75R[B]_f 02.9.5, 4:11 PM15