Filter
Top Products
10
To turn off the unit automatically (Auto Standby)
Using the Auto Standby function, the unit automatically turns
itself off if no sound comes in for more than 3 minutes when
“CD” or “TAPE” is selected as the source.
If an operation is done within this 3-minute period, the Auto
Standby function is canceled temporarily even though no
sound comes in.
• You can also turn off the unit automatically by using the
sleep timer. (See page 29.)
On the remote control ONLY:
To activate the Auto Standby function,
press A.STANDBY.
The AUTO STANDBY indicator lights up
on the display.
• When no sound comes in, the AUTO STANDBY indicator
starts flashing on the display. About 5 seconds before the
unit turns itself off, “AUTO STANDBY” starts flashing on
the display.
To deactivate the Auto Standby function, press
A.STANDBY.
The AUTO STANDBY indicator goes off.
AUTO STANDBY indicator
Turning On the Power
To turn on the unit, press STANDBY/ON
(or on the unit).
The STANDBY/ON lamp on the unit lights
green.
• When you press the source button—3/8 CD,
2 3 TAPE, FM/AM and AUX (or AUX/DVD on the unit),
the unit automatically turns on and starts playback if the
source is ready.
• Pressing one of the disc eject buttons (CD10 – CD50)
also turns on the unit. (See page 17.)
• Pressing 0 (tape eject) also turns on the unit. (See page
22.)
To turn off the unit (standby), press STANDBY/ON (or
on the unit) again.
The STANDBY/ON lamp on the unit lights red.
•“0:00” flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is on standby.
• A little power is always consumed even while the unit is in
standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations will be erased in a few days.
STANDBY/ON
A.STANDBY
AUTO
STANDBY
Continued
09_12UX_B70[B].p65 03.4.15, 8:10 PM10