Filter
Top Products
9
Basic and Common Operations
Setting the Clock
Before operating the unit any further, first set the unit’s clock.
When you plug in the power cord, “0:00” starts flashing on
the display.
You can set the clock when the unit is either turned on or in
standby mode.
On the remote control ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Press DISC UP or DISC
DOWN to adjust the hour, then
press CLOCK/TIMER.
The minute digits start flashing.
• When you press and hold DISC UP
or DISC DOWN, the hour digit changes
continuously.
3
Press DISC UP or DISC DOWN to
adjust the minute, then press
CLOCK/TIMER.
The built-in clock starts.
• When you unplug the power cord or if a power failure occurs
The clock is reset to “0:00” right away. If this happens, set the
clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY.
The clock indication appears on the display.
To return to the normal display, press DISPLAY
again.
To change the clock
1 Make sure the (timer) indicator and the timer mode
indicator (DAILY or REC) are not lit on the display.
• If they are lit, press and hold CLOCK/TIMER until they
go off.
2 Press CLOCK/TIMER repeatedly until the unit enters
the clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER, the unit enters the
timer setting mode. (See page 27.)
3 Repeat steps
2
and
3
of the procedure “Setting the
Clock.”
4 Press and hold CLOCK/TIMER again so that the
(timer) indicator and the timer mode indicator (DAILY
or REC) go off.
To turn off the clock indication (power save mode)
On the remote control ONLY:
Press DISPLAY while the unit is in standby mode.
“DISPLAY OFF” appears on the display and the
clock indication goes off.
To turn on the clock indication, press DISPLAY again
while the unit is in standby mode.
“DISPLAY ON” appears on the display.
CLOCK/
TIMER
DISC UP
DISC DOWN
CLOCK/
TIMER
DISPLAY
DISPLAY
09_12UX_B70[B].p65 03.4.17, 5:52 PM9