Filter
Top Products
– 33 –
Changing the Initial Language Settings
On LANGUAGE menu, you can select the following initial
languages.
• MENU LANGUAGE :Select the DVD menu language.
Selectable languages—ENGLISH, SPANISH, FRENCH,
CHINESE, GERMAN, ITALIAN, JAPANESE, AA – ZU.
(Language code: see page 46.)
• AUDIO LANGUAGE :Select the initial language for
audio sound language.
Selectable languages—ENGLISH, SPANISH, FRENCH,
CHINESE, GERMAN, ITALIAN, JAPANESE, AA – ZU.
(Language code: see page 46.)
• SUBTITLE :Select the initial language for
subtitles.
Selectable languages—ENGLISH, SPANISH, FRENCH,
CHINESE, GERMAN, ITALIAN, JAPANESE, AA – ZU.
(Language code: see page 46.)
• ON SCREEN LANGUAGE :
Select the language for the on-
screen menus and indications.
Selectable languages—ENGLISH, ESPAÑOL (Spanish),
FRANCAIS (French)
NOTICE: The original language will be selected as the initial
language regardless of your setting in the following cases.
– If the language you have selected is not recorded on the
disc.
– If the disc is programed to be played back in the original
language.
MENU LANGUAGE
AUDIO LANGUAGE
SUBTITLE
ON SCREEN LANGUAGE
ENGLISH
ENGLISH
ENGLISH
ENGLISH
EXIT
PRESS KEY
Changing the Various Audio Settings
On AUDIO menu, you can change the following sound
settings.
• DIGITAL AUDIO OUTPUT :
Set the output signal type through the OPTICAL
DIGITAL OUTPUT terminal. (For the output signal
types, see page 45.)
– Select “STREAM/PCM” when connecting an
amplifier or a decoder compatible with DTS and
Dolby Digital.
– Select “PCM ONLY” when connecting a digital
recording device such an MD recorder, DAT deck, etc.
– Select “DOLBY DIGITAL/PCM” when connecting
an amplifier or a decoder compatible only with Dolby
Digital.
• DOWN MIX :
Set the output signal type through the AUX OUT jacks
while playing Dolby Digital 5.1ch software.
– Select “L0/R0” to output left front and right front
channels (2ch) without mixing.
– Select “Lt/Rt” to mix multichannel signals into left
front and right front channels (surround signals are
added to left/right front channels), then output.
• The PRO LOGIC lamp lights up while down-mix
signlas are output through the AUX OUT jacks.
– Select “OFF” not to mix but to output original signals.
• COMPRESSION :
Compress the dynamic range (difference between the
maximum and minimum sound levels) while playing a
source encoded with Dolby Digital. This is useful when
listening at a low volume level.
– Select “ON” to apply dynamic compression.
– Select “OFF” not to apply dynamic compression (full
dynamic range recorded on the original disc.)
• SPEAKER SETTING :
Set the speaker’s output level and delay time according to your
speaker setting in your listening room. (See the next page.)
– Select “5.1CHANNEL” if all the speakers are located
at the same distance from the listening position.
– Select “EXPERT” if you cannot locate all the
speakers at the same distance from the listening
position. Select “EXPERT” to enter EXPERT
SPEAKER SETTING menu, then press ENTER.
DIGITAL AUDIO OUTPUT
DOWN MIX
COMPRESSION
SPEAKER SETTING
STREAM/PCM
OFF
OFF
5.1CHANNEL
EXIT
PRESS KEY
EN32-37.MX-DVA9[J]_1 01.7.3, 10:23 AM33