Filter
Top Products
– 10 –
Common Operations
Turning On or Off the Power
To turn on the unit, press
STANDBY/ON so that the
STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from a wall outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “AM 12:00” right away, while the tuner preset
stations (see page 13) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn 4 / ¢ to adjust
the hour, then press SET.
The minute digits start flashing on
the display.
• If you want to correct the hour after
pressing SET, press CANCEL/DEMO.
The hour digits start flashing again.
DAILY
Canceled
ON TIME
(Daily timer setting)
ON TIME
(Recording
timer setting)
Clock
setting
(The hour digits
start flashin
g
.
)
REC
3
Turn 4 / ¢ to adjust the minute, then
press SET.
To check the clock time
Press and hold SET while playing any source.
• Pressing SET, the source indication appears again.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “AM 12:00” right away. If this happens, set the
clock again.
Selecting the Sources
To listen to the FM/AM broadcasts, press FM/AM.
(See page 13.)
To playback discs, press DVD 3¥8 (or DVD 3 on the
remote control). (See pages 14 – 26.)
To playback tapes, press TAPE 2 3. (See page 27.)
To select the external equipment as the source, press AUX.
When you press the play button for a particular source
(FM/AM, DVD 3/8 (or DVD 3 on the remote control),
TAPE 2 3, and AUX), the unit turns on (and the unit starts
playing the source if it is ready).
STANDBY/ON
STANDBY
STANDBY/ON
STANDB
Y
Continued
EN01-13.MX-DVA9[J,C]_f 01.7.3, 3:09 PM10