Filter
Top Products
3
English
ANTENNA
AM
EXT
AM
LOOP
FM 75
COAXIAL
AM
LOOP
ANTENNA
AM
EXT
FM 75
C
O
A
X
IA
L
AM
LOOP
ANTENNA
AM
EXT
FM 75
C
O
A
X
IA
L
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply.
Before Installation
General
• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to
connect.
Locations
• Install the receiver in a location that is level and protected from
moisture.
• The temperature around the receiver must be between –5˚ and 35˚
C (23˚ and 95˚ F).
• Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Handling the receiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or
cabinet.
• Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
If anything is missing, contact your dealer immediately.
Setting the Voltage Selector Switch
Before connections, always set the voltage selector switch first if
necessary.
Set the correct voltage for your area
with the voltage selector switch on the
rear panel.
Use a screw driver to rotate the switch
so the number the arrow is pointing at
is the same as the voltage where you
are plugging in the receiver.
A
B
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75Ω
COAXIAL terminal as temporary measure.
B. Using the Standard Type Connector (Not Supplied)
A standard type connector should be connected to the FM 75Ω
COAXIAL terminal.
Note:
If reception is poor, connect the outside antenna.
Before attaching a 75
Ω
coaxial cable (the kind with a round wire going
to an outside antenna), disconnect the supplied FM antenna.
FM Antenna
Connecting the FM and AM Antennas
FM Antenna Connections
Extend the supplied FM antenna horizontally.
Outside FM Antenna Cable
127V
VOLTAGE SELECTOR
220V
230
-240V
110V
EN01-07.RX-669PGD[UB]/f 99.2.2, 1:17 PM3