Filter
Top Products
12
ENGLISH
What you can do with RDS
Radio Data System (RDS) allows FM
stations to send an additional signal along
with their regular programme signals.
By receiving the RDS data, this receiver can
do the following:
•
Programme Type (PTY) Search (see page 11)
• Standby Reception of Traffic
Announcement—TA (see the following) or
PTY (see pages 13 and 23)
•
Tracing the same programme automatically
—Network-Tracking Reception (see page 13)
• Programme Search (see page 23)
Storing your favorite programmes
You can store six favorite programme types.
Preset programme types in the number buttons
(1 to 6):
1 Select a PTY code (see page 11).
2 Select the preset number (1 – 6) you
want to store into.
Ex.: When “SOCIAL” is stored
3 Repeat steps 1 and 2 to store
other PTY codes into other preset
numbers.
4 Finish the procedure.
Using the standby receptions
You can use two types of Standby Reception—
TA Standby Reception and PTY Standby
Reception—both for FM station and DAB
services.
TA Standby Reception
TA Standby Reception allows the receiver
to switch temporarily to an FM RDS station
or a DAB service broadcasting Traffic
Announcement from any source other than AM.
The volume changes to the preset TA volume
level (see page 23).
To activate TA Standby Reception
The TP indicator either
lights up or flashes.
• If the TP indicator lights up, TA Standby
Reception is activated.
• If the TP indicator flashes, TA Standby
Reception is not yet activated.
To activate TA Standby Reception, tune in
to another FM RDS station or DAB service
providing the signals required for TA Standby
Reception. The TP indicator will stop flashing
and remain lit.
To deactivate the TA Standby Reception
The TP indicator goes off.
EN12-19_KD-DB711[EX]f.indd 12EN12-19_KD-DB711[EX]f.indd 12 1/12/05 4:12:51 PM1/12/05 4:12:51 PM