Filter
Top Products
6
-EN
1
POWER button
Press to turn the power ON or OFF.
2
POWER Indicator
The green LED lights when the POWER is set to ON.
3
STANDBY Indicator
The red LED is extinguished when the POWER is ON, but
lights when it is OFF to indicate the Standby mode.
If the unit power has been switched OFF to the
Standby mode and then ON again, it can be oper-
ated using the same settings as when the power
was switched OFF.
4
SOURCE SELECT buttons (
☞
p. 11, 13, 15, 17)
Press to select an input component.
5
SOURCE SELECT indicators
(
☞
p. 11, 13, 15, 17)
The indicator of the input component selected by the
SOURCE SELECT button lights in red.
Connectors, Controls and Indicators
Front Panel
6
DUBBING LOCK button (
☞
p. 14, 20)
(MONITOR SELECT)
Press to disable the POWER and LOOP PROTECT button
and fix the circuit output to the output connectors. This
button is useful for preventing accidental or erroneous
operation during dubbing. It lights in green when it is “ON”.
• When one of the SOURCE SELECT buttons is pressed
while DUBBING LOCK is activated, only the VIDEO out-
put from the MONITOR output is switched without chang-
ing the video signal being dubbed through the VIDEO
output.
7
LOOP PROTECT button (
☞
p. 13, 15, 19)
Press this button when you don’t want the signal selected
by the SOURCE SELECT button to be sent to the corre-
sponding output terminal.
• ON: The input (video/audio) signals are not output at the
output terminal having the same number as the in-
put terminal.
• OFF: The input (video/audio) signals are output at the
output terminal having the same number as the in-
put terminal.
8
Input terminals (INPUT 3)
INPUT 3 : This set of input terminals includes an S-VIDEO
input terminal, VIDEO input terminals and AU-
DIO input terminals. It is used for dubbing from
a camcorder, etc.
9
Remote sensor
The remote control signals enter the unit by this route.
STANDBY
SOURCE SELECT
DUBBING LOCK
(MONITOR SELECT)
LOOP PROTECT
S-VIDEO
INPUT 3 • • •
VIDEO AUDIOLR
POWER
JX-S555 AV SELECTOR
12345
1
9
8
23 45 6 7
MEMO