Filter
Top Products
24
-EN
Troubleshooting
Power No power
Unit cannot be turned
OFF
Symptom PageCause Remedy
•Is the power cord disconnected from
the AC outlet?
•Make sure that the DUBBING LOCK
function is set to ON.
•Insert the power plug firmly into the AC
outlet.
•Press the POWER button after setting
the DUBBING LOCK function OFF.
•Is the required video component con-
nected to the corresponding INPUT/
OUTPUT terminals correctly?
•Is the monitor TV connected to the
MONITOR OUT terminals correctly?
Playback
Required
picture won’t appear
•Check the connections again and re-
connect correctly.
•Check the connections again and re-
connect correctly.
The picture appears
distorted during
playback
•Is the LOOP PROTECT button pressed
OFF?
•Set the LOOP PROTECT button to ON.
•Are the playback and recording VCRs
connected correctly to the INPUT/
OUTPUT terminals? Also, is the cor-
rect SOURCE SELECT button se-
lected?
• Is the DUBBING LOCK function set?
•Is the input select switch on the re-
cording VCR set to the “AUX” posi-
tion?
•Is the video input select switch on the
recording VCR with S-VIDEO termi-
nals set to the “S-VIDEO IN” position
or “VIDEO input” position?
Recording
No picture recorded
on the edited tape.
•Check the connections again and re-
connect correctly before selecting
the correct SOURCE SELECT button.
•Press DUBBING LOCK to OFF before
pressing a SOURCE SELECT button.
•Set the input select switch on the re-
cording VCR to “AUX”.
•Set the video input switch on the re-
cording VCR to the correct position.
•Some video software may contain sig-
nals to prevent it from being copied. If
you try to copy such a program, the
results will not be viewable.
•Conversion is not possible from the
component terminal to the S-VIDEO/
VIDEO terminals.
Dubbing operations
are not possible when
using equipment con-
nected to the compo-
nent terminal.
•Use the S-VIDEO terminal or connect
a recording VCR to the MONITOR OUT
2 terminal.
—
20
10,14
10,14
11,19
12,13
14, 20
13
13
—
16
• The JX-S555 incorporates a microcomputer, which may malfunction due to external interference
or noise. If this trouble cannot be resolved by checking the items in the following table, reset the
microcomputer by turning off the JX-S555, unplugging its power cord from the wall outlet, plug-
ging it in again and then checking the operation.
• Are the video components etc. con-
nected to the AUDIO input terminals
correctly?
No sound recorded
on the edited tape
•Check the connections again and re-
connect correctly.
12