Filter
Top Products
50
To change the transmittable signals for
operating a CATV converter
1. Set the remote control mode to “CATV/DBS.”
2. Press and hold CATV/DBS POWER.
3. Press TV/DBS.
4. Enter manufacturer’s code (two digits) using
buttons 1–9, and 0.
See the list below to find the code.
Examples: For an RCA product, press 1, 9.
For a SONY product, press 2, 0.
5. Release CATV/DBS POWER.
After setting the remote control mode selector to “CATV/DBS,”
you can perform the following operations on the CATV
convertor :
CATV/DBS POWER Turns on and off the CATV converter.
CHANNEL +/– Changes the channels.
1 – 10, 0, 100+ (+10) Selects the channels.
The 100+ (+10) button will function as
the ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Notes:
• Refer to the manual supplied with your CATV converter.
• You cannot set the remote control mode selector both for the
CATV converter and the DBS tuner at the same time.
6. Try to operate your CATV converter by pressing
CATV/DBS POWER.
When your CATV converter turns on or off, you have entered
the correct code.
If there are more than one code listed for your brand of
CATV converter , try each one until the correct one is entered.
To change the transmittable signals for
operating a DBS tuner
1. Set the remote control mode to “CATV/DBS.”
2. Press and hold CATV/DBS POWER.
3. Press TV/DBS.
4. Enter manufacturer’s code (two digits) using
buttons 1–9, and 0.
See the list below to find the code.
Examples: For a JVC product, press 2, 1.
For an RCA, press 2, 9.
5. Release CATV/DBS POWER.
After setting the remote control mode selector to “CATV/DBS,”
you can perform the following operations on the DBS tuner:
CATV/DBS POWER Turns on and off the DBS tuner.
CHANNEL +/– Changes the channels.
1 – 10, 0, 100+ (+10) Selects the channels.
The 100+ (+10) button will function as
the ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Notes:
• Refer to the manual supplied with your DBS tuner.
• You cannot set the remote control mode selector both for the
CATV converter and the DBS tuner at the same time.
6. Try to operate your DBS tuner by pressing
CATV/DBS POWER.
When your DBS tuner turns on or off, you have entered the
correct code.
Manufacturer Codes
GI JERROLD 01, 02, 03, 04, 05,
06, 07, 08
HAMLIN/REGAL 15, 16, 17, 18
PIONEER 13, 14
RCA 19
SCIENTIFIC ATLANTA 09, 10
SONY 20
ZENITH 11, 12
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
Manufacturer Codes
JVC 21
ECHOSTAR 22
GI 23
HITACHI 24
HTS 25
HUGHES
NETWORK SYSTEMS
PANASONIC 27
PRIME STAR 28
RCA 29, 30
SONY 31
TOSHIBA 32
26
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
EN44_54.RX-8000V[J]/f 00.1.12, 0:13 PM50