Filter
Top Products
32
From the remote control:
1. Press DVD MULTI so that “DVD
MULTI” appears on the display.
Note:
When you select “DVD MULTI” as the source to play, the DSP
mode is canceled temporarily, and the SURROUND ON/OFF and
SURROUND MODE buttons do not work.
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the following
steps.
3. Press SOUND.
The 10 keys are activated for adjusting the sound.
4. Adjust the speaker output levels.
• To adjust the center speaker level, press CENTER –/+ (from –
10 dB to +10 dB).
• To adjust the left rear speaker level, press REAR•L –/+ (from
–10 dB to +10 dB).
• To adjust the right rear speaker level, press REAR•R –/+ (from
–10 dB to +10 dB).
5. Press CNTR TONE to select the
center tone level you want.
• Each time you press the button, the display
changes to show the following:
To make the dialogue clearer, select “CENTER SHARP1”
(little) or “CENTER SHARP2” (much).
To make the dialogue softer, select “CENTER SOFT 1” (little)
or “CENTER SOFT 2” (much).
When “CENTER FLAT” is selected, no adjustment is applied.
DVD MUILTI
––––––––––––––– MEMO –––––––––––––––
Use this column to write down your DVD MULTI playback
mode adjustments for your future reference.
SOUND
CENTER
23
MENUMENU
REAR•L
56
ENTERENTER
REAR•R
89
CNTR TONE
1
CENTER FLAT
(Canceled)
CENTER SHARP1 CENTER SHARP2
CENTER SOFT2CENTER SOFT 1
EN21_32.RX-8000V[J]/f 00.1.12, 0:08 PM32