Filter
Top Products
31
Using the DVD MULTI Playback Mode
This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD
player. Before playing back a DVD, refer also to the manual supplied with the DVD player.
4. Adjust the center tone.
1) Press BALANCE/SURROUND
ADJUST repeatedly until “CENTER
TONE” appears on the display.
The display changes to show the current
setting.
2) Turn MULTI JOG to select the center
tone level you want.
The center tone adjustment affects the
mid-frequency range, which the human
voice is mostly made up of.
• As you turn it, the display changes to
show the following:
To make the dialogue clearer, select “CENTER SHARP1”
(little) or “CENTER SHARP2” (much).
To make the dialogue softer, select “CENTER SOFT 1” (little)
or “CENTER SOFT 2” (much).
When “CENTER FLAT” is selected, no adjustment is applied.
IMPORTANT:
When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate this receiver, set it to “AUDIO/TV/
VCR.”
Activating the DVD MULTI Playback Mode
You can adjust the DVD MULTI playback mode while playing back
a DVD using the analog discrete output mode on the DVD player.
Once you have made adjustments, the receiver memorizes the
adjustments until you change them. You also need to set the DVD
player to the analog discrete output mode.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel:
1. Turn SOURCE SELECTOR until
“DVD MULTI” appears on the
display.
Note:
When you select “DVD MULTI” as the source to play, the DSP
mode is canceled temporarily, and the SURROUND ON/OFF and
DSP MODE buttons do not work.
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the following
steps.
3. Adjust the speaker output levels.
1) Press BALANCE/SURROUND
ADJUST repeatedly until one of the
indications appears on the display.
“CENTER LEVEL”:
To adjust the center speaker level.
“REAR L LEVEL”:
To adjust the left rear speaker level.
“REAR R LEVEL”:
To adjust the right rear speaker level.
2) Turn MULTI JOG to adjust the
selected speaker output level (from –10
dB to +10 dB).
3) Repeat 1) and 2) to adjust the other
speaker output levels.
AUDIO/
TV/VCR
CATV/DBS
BALANCE/SURROUND
ADJUST
MULTI JOG
CENTER FLAT
(Canceled)
CENTER SHARP1 CENTER SHARP2
CENTER SOFT 2CENTER SOFT 1
SOURCE SELECTOR
BALANCE/SURROUND
ADJUST
MULTI JOG
EN21_32.RX-8000V[J]/f 00.1.12, 0:08 PM31