Filter
Top Products
46
Operating Other Manufacturers’ Video Equipment
This remote control supplied with the receiver can transmit control
signals for other manufacturers’ VCRs, TVs, and CATV converters.
By changing the transmittable signals from preset ones to the other
manufacturers’, you can operate the other manufacturer’s
components using this remote control.
When operating the other manufacturers’ components, refer also to
the manuals supplied with them. To operate these components with
the remote control, first you need to set the manufacturer’s code
each for VCR, TV, and CATV converters.
To change the transmittable signals for
operating another manufacturer’s TV
1. Set the remote control mode to “AUDIO/TV/
VCR.”
2. Press and hold TV POWER.
3. Press TV/DBS.
4. Enter manufacturer’s code (two digits) using
buttons 1–9, and 0.
See the list below to find the code.
Examples: For a JVC product, press 0, 1.
For a SANYO product, press 1, 3.
5. Release TV POWER.
The following buttons can be used for operating the TV (with
the remote control mode selector set to “AUDIO/TV/VCR”):
TV POWER Turns on and off the TV.
TV VOL +/– Adjusts the volume.
TV/VIDEO Sets the input mode (either TV
or VIDEO).
After pressing TV/DBS (with the remote control mode selector
set to “AUDIO/TV/VCR”), you can perform the following
operations on a TV:
CHANNEL +/– Changes the channels.
1 – 10, 0, 100+ (+10) Selects the channels.
The 100+ (+10) button will function
as the ENTER button if your TV
requires pressing ENTER after
selecting a channel number.
Note:
Refer to the manual supplied with your TV.
6. Try to operate your TV by pressing TV POWER.
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of TV,
try each one until the correct one is entered.
Check to see if the remote
control mode selector is set
to the correct position.
To operate the audio
system, TVs, and VCRs,
set it to “AUDIO/TV/VCR.”
To operate the CATV
converter, set it to “CATV/
DBS.”
Manufacturer Code Manufacturer Code
JVC 01 SAMSUNG 12
HITACHI 10 SANYO 13
MAGNAVOX 02 SHARP 06
MITSUBISHI 03 SONY 07
PANASONIC 04, 11 TOSHIBA 08
RCA 05 ZENITH 09
Manufacturers’ codes are subject to change without notice.
If they are changed, this remote control cannot operate the
equipment.
AUDIO/
TV/VCR
CATV/DBS
RM-SRX7000J REMOTE CONTROL
CONTROL
CHANNEL VOLUMETV VOL
TUNING
STOP PAUSE
FF/
/REW
VCR
TV/VIDEO
TAPE/MD
MUTING
REC
PLAY
DOWN UP
AUDIOTV
DVD DVD MUILTI CD TAPE/MD
TV/DBS PHONO FM/AM
VCR
ANALOG/DIGITAL
SURROUND
CENTER
SURROUND
TEST REAR-L
CD-DISC
MODE
ON/OFF
EFFECT REAR-R
SOUND
SEA MODE
SUBWOOFER
RETURN FM MODE
SET
MENU
AUDIO/
TV/VCR
EXIT
TEXT
DISPLAY
SLEEP
123
456
7
/P 89
10
0
+10
100+
CATV/DBS
MENUMENU
ENTERENTER
CATV/DBS
VCR
EN41_50.RX-7000V[J]/f 00.1.12, 0:01 PM46