JVC HA-W1000RF-J/C Headphones User Manual


 
1514
ENGLISH
HOW TO USE
M
IN
P
O
W
E
R
/
C
H
A
R
G
E
W
O
W
O
F
F
S
U
R
R
O
U
N
D
L
E
V
E
L
M
A
X
T
r
u
B
a
s
s
V
O
L
V
O
L
1. Connect the transmitter and AV equipment. (Refer to page 10)
2. Connect the AC adaptor to the transmitter, then plug the AC adaptor into an
AC outlet. (Refer to page 11)
3. Turn on the power on the transmitter and the connected AV equipment.
Transmitter power
When an audio signal is input, the transmitter’s power is turned on automatically, and the
indicator lights in green. Also, when no audio signal is input for about a minute, the
indicator goes out automatically and the power turns off. (Automatic Power On/Off function)
The Automatic Power On/Off function is activated from audio on the left channel. The
function may not activate properly in situations when the audio signal is detected only from
the right channel.
In some situations, the power may not be turned on automatically by the input sound
(e.g. a song with a quiet opening or gradual fade-in). This is not a malfunction.
4. To avoid excessive volume, first set the headphones’ volume to a low level
and fit them to the head to automatically turn on the power. Turn the
receiver power on after confirming transmitter’s power on.
5. When the power goes on, tuning begins automatically. Tuning may take
few seconds and sound is not heard during this procedure. This is not
a malfunction.
Before using the headphones for the first time, charge the rechargeable battery.
CAUTIONS ABOUT CHARGING
1. Be sure to use only this unit for charging.
2. You can charge the rechargeable battery approximately 500 times.
3. Charging times differ depending on the temperature range or the remaining
charge in the battery.
4. Excessive charging doesn’t result in malfunction.
5. Battery life will decrease in cold places.
6. Due to characteristics of the batteries, they expend their charge a little even
when the power is turned off.
7. Be sure to use the provided AC adaptor (model J47310-001)
OTHER CAUTIONS
1. Caution! To avoid risk of fire or injury, do not attempt to charge non-rechargeable
batteries.
2. Replace only with the same type recommended by the manufacturer.
3. Please dispose of old, defective batteries in an environmentally friendly manner
in accordance with the relevant legislation.
4. No naked flame sources, such as lighted candles, should be placed on the
apparatus.
5. The unit shall not be exposed to dripping or splashing and that no objects filled
with liquids, such as vases, shall be placed on or by the unit.
6. For indoors use only. Do not expose to rain.
7. Don’t open, no user serviceable parts inside.
If the batteries are used incorrectly, they may leak, heat or explode, and may cause
fire, injury or soiling. Make note of the following:
1. Be sure to use the provided exclusive battery. Do not use any other
rechargeable or dry cell battery.
2. Do not throw the battery in a fire or heat it.
3. Do not deform, take apart, modify or directly solder the battery.
4. Do not remove or damage the covering tube.
5. If any liquid from the battery gets into your eyes, it may cause blindness.
If battery liquid does get into your eyes, do not rub them, but instead
immediately wash them thoroughly with clean water, then consult a doctor at
once. Also, should any liquid from the rechargeable battery get onto your skin or
clothes, it may burn your skin. In this case, wash with clean water immediately.
6. Do not immerse or wet the battery in water.
7. Do not use or leave the battery in an area where the temperature becomes
significantly higher, such as in direct sunlight, inside a car on hot day or near
heat-generating equipment.
8. Do not subject the battery to strong shocks or throw it.