Filter
Top Products
Introduction
5
Preparation
Connections
1 Set up the AM loop antenna
(supplied).
2 Connect the antenna cord.
3
Turn the AM loop antenna to find the
best position for radio reception.
• Place the AM loop antenna as far from the
main unit as possible.
• Do not place the AM loop antenna on a
metallic table or close to TV, personal
computer, etc. It may result in bad radio
reception.
■ When radio reception with the AM loop
antenna is poor
■ When radio reception is poor with the
supplied FM antenna, or when using a
communal antenna
For details of connecting a separately sold
antenna, refer to the instruction manual for the
antenna or converter.
Connecting the Antennas
Connecting the AM antenna
Insert the tab int
o
the slot.
Main unit (rear view)
Main unit (side view)
Connect the ends of the
antenna cord as shown
above.
When insulation
covers the tips of
the antenna cord,
twist and pull off
the insulation.
Electric wire: 3 - 5 m (not supplied
Twist electric wire and
the AM loop antenna
cord together.
Stretch out the electric
wire horizontally.
Main unit (rear view)
AM loop antenna cord
Electric wire
Main unit (side view)
Keep the AM loop
antenna connected.
Connecting the FM antenna
Main unit
(side view)
Main unit
(rear view)
FM antenna
(supplied)
Stretch out the FM
antenna to the best
position for radio
reception, then fix it
with adhesive tape.
Depending on the radio reception conditions, an
FM feeder antenna (not supplied: compatible with
300 Ω) can be used. In this case, a converter (not
supplied) is required.
Main unit (rear view)
Antenna cord (not supplied)
Communal
antenna terminal
or
Outdoor FM antenna
(
not supplied
)
Coaxial cable
(not supplied)
Converter (not supplied:
compatible with 300
Ω/75 Ω)
Main unit (side view)
Do not connect the AC power cord until all other connections have been made.
When positioning the antennas, find the best
position for reception while listening to an actual
radio program (refer to "Listening to the Radio"
( page 13)).
UX-QX3W_A[A].book Page 5 Friday, July 21, 2006 4:37 PM