Filter
Top Products
34
ENGLISH
6 Press number button 3 to start erasure.
“Now Deleting...” appears while
erasing the selected file. When
erasure is over, the name list of the
stored file appears again.
7 To delete more files, repeat from steps 5 and 6.
8 Press D DISP to resume the source indication
screen.
Activating the downloaded
images and animations
Activating the animations stored for
opening and ending screens
After the unit turns on or before the unit turns off,
you can see preset animations on the display.
These are called opening screen and ending
screen. You can use your own edited animations
for these opening and ending screens.
• Before performing the following procedure,
make sure that “KeyIn CFM” is set to “On”;
otherwise, the animations may not be shown.
(See page 38.)
• If no animation is stored in “Opening” and
“Ending,” “Opening” and “Ending” cannot be
selected as a PSM item.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
(PSM: see pages 36 and 37.)
2
Press number button 1 to select
“MOVIE”—Movie category of the
PSM settings.
The “Graphics” setting screen appears on
the display.
3
Select “Opening” (opening screen
setting) or “Ending” (ending screen
setting).
4
Select “User.”
• Default: Factory-preset animation is used.
• User: Your own edited animation is
used.
5
Finish the setting.
Activating the graphic screen using
either picture or movie
Using this setting, you can change the graphic
displays. These graphic screen appears if no
operation is done for about 20 seconds.
• If no image is stored in “Picture,” or no
animation in “Movie,” “UserPict.,” “UserMovie,”
and “UserSlide” cannot be selected as a PSM
item.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
(PSM: see pages 36 and 37.)
Ex.: When you select “Opening”
EN29-35_KD-AR3000LH300[J]f.p65 20/11/03, 4:13 PM34