Filter
Top Products
Regulatory Notications to User
CZ76372,00003A2 -19-12DEC11-1/1
CZ76372,00003A3 -19-12DEC11-1/1
CZ76372,00003A4 -19-12DEC11-1/1
CZ76372,00004C3 -19-21MAY12-1/1
Information to User
This device must be operated as supplied by John Deere
Ag Management Solutions. Any changes or modications
made to these devices without the express written
approval of John Deere Ag Management Solutions may
void the user’s authority to operate this device.
United States
This device complies with FCC Part 15. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause
harmful interference in which case the user will be
required to correct the interference at their own expense.
This device has been found to be compliant to the
requirements set forth in CFR 47 Sections 2.1091,
and 15.247 (b) (4) addressing RF Exposure from radio
frequency devices as dened in Evaluating Compliance
with FCC Guidelines for Human Exposure to Radio
Frequency Electromagnetic Fields.
Canada
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
This device has been designated to operate with the
antenna(s) listed below, and having a maximum gain of
5 dBi. Antennas not included in this list or having a gain
greater than 5 dBi are strictly prohibited for use with this
device. The required antenna impedance is 50 Ohms.
Antenna part number = PFP11422
This Class A digital apparatus meets all the requirements
of the Canadian Interference-Causing Equipment
Regulations.
This device complies with Health Canada’s Safety Code 6
/ IC RSS-210. The installer of this device should ensure
that RF radiation is not emitted in excess of the Health
Canada’s requirement.
Information can be obtained at: http://www.hc-
sc.gc.ca/ewh-semt/pubs/radiation/radio_guidelignes_di-
rect-eng.php
European Community
This equipment operates in the 2402 to 2472 MHz
frequency range. Check with local authorities for the latest
status of national regulations for the 2.4 GHz wireless
bands. National regulations may require that operations
be limited to portions of the frequency ranges identied
above.
France
Do NOT operate the Machine Communication Radio on
Channel C in France. Only use Channels A and B in
France.
PC13686 —UN—13DEC11
In France, the output power is restricted to 10 mW EIRP
when the product is used outdoors in the 2454-2483.5
MHz band. This restriction only impacts Channel
9 (Channel C). It does not affect Channel 1 (Channel A)
and Channel 5 (Channel B).
10-1
052912
PN=8