Filter
Top Products
➔➔
➔➔ ➔
STEP 6: To remove the front bucket seats, you
use a 15mm socket(not supplied) for the front nuts
and a 12mm(not supplied) for the rear bolts.
Tilt the seats backward to access and discon-
nect the wiring.This does include the air bag
wire.
STEP 10: To remove the OEM console, lift up on
the rear of the console and pull it back away from
the dash.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 7: Once the front seats have been
removed, you will need to outline the outside of
the center console with masking tape(not supplied).
This will help in future steps.
STEP 11: *TRUCKS ONLY*
With the console out, there is duct work that is exposed from under the dash. Remove the plastic duct that is attached to
the upper duct work.With the lower duct piece removed, it now exposes a door.
Insert the key into the ignition, turn to the accessory position, turn on the A/C.When the A/C is turned on, this willalloe the
exposed door to open.
This door is opened by a C-bracket that comes down from the upper dash.This C-bracket needs to be removed. If this
bracket is not removed, the A/C air flow will be not be correct.
This C-bracket is attached to the door and a motor that us located in the upper dash. Push the C-bracket to the passenger
side of the truck.This will detach the bracket from the door.With the C-bracket in hand, reach up as far up on the bracket
and push towards the passenger side of the truck.This will detach the C-bracket from the motor. Give the C-bracket to the
owner of the truck or store inside the truck for safe keeping.This bar will need to be reinstalled, If the Stealthbox is removed
and air flow is needed to the rear vents.
Use a small screw(not supplied) to hold this door shut. If this door is not screwed shut, air will blow on the driver’s feet and
reduce pressure from the dash vents.
➔
STEP 8: With the upper storage pocket panel
removed.You can view a pair of bolts. Using a 10mm
socket(not supplied), remove these bolts.
If you have not removed th front seats, there are
other bolts and screws that need to be located and
removed.This is to allow the console to be removed
out of the vehicle.
STEP 9: Look down in the console from the cup
holder area.You need to locate and disconnect a
white connection plug. Pull the lever on this white
connection plug to disconnect from the wire har-
ness..
SB-GM-BURBCNSL/10W3v2, JL AUDIO, Inc 2005
Sheet SKU#011167 3/08/2005Page 2
www.jlaudio.com
*WARNING*
If you have removed the front seats, you need to place
both front seats back into the vehicle and reconnect the
wires from STEP 6. Do not secure the seats back to
the floor.
Reconnect the ground wire to the negative side of the
battery.
Follow next step (STEP 11) and then repeat procedure
to remove the front seats. (caution before STEP 6)
*CAUTION*
The vehicle that you are working on might be
equipped with side impact air bags.To remove the
front seats, please follow these required procedures.
1)Disconnect the ground wire from the negative
side of the battery.
2)Let the vehicle sit for 15 minutes.This allows the
air bags to discharge.
3)Now you can remove the front seats and discon-
nect the air bag wire.
If you are not comfortable with disconnecting the air
bag wires.This install can be accomplished by not
removing the front seats. It will be tight quarters.
*Trucks* If you remove the front seats, you will
have to place the seats back in and reconnect the
air bag wires.Then repeat the removal process, in
future steps. You might not want to remove the
seats till then.