JL Audio TR400-CXI Speaker User Manual


 
➔➔
STEP 38: The passenger’s side mark line goes
from the bottom mark line from STEP 37, angling
up to the upper corner of this exposed upper wall.
STEP 42: Place the OEM console into the vehicle.
Sleave the OEM console over the Stealthbox. Make
sure that the OEM consoles mounting legs are
placed back over the OEM position studs.
Cont.
From
Previous
Page
Continued on Next Page
STEP 39: The driver’s side mark line goes from
the bottom mark line from STEP 37, angling up to
this upper corner of this exposed upper wall.
STEP 43: When the OEM console is place over
the Stealthbox. It should be snug.
If there are any obstructions, that do not allow the
OEM console to fit properly.Trimming of the inner
console is needed. Mark the obstruction and cut
only what is needed.
STEP 40: The upper mark line goes across the
top, using this exposed front edge.
STEP 41: Time to cut. Follow the mark lines
with the cutting tool.
After all cutting is completed. Reassemble the inner
console and outer console back together.
SB-GM-BURBCNSL/10W3v2, JL AUDIO, Inc 2005
Sheet SKU#011167 3/08/2005Page 6
www.jlaudio.com
STEP 36: This the view of the passenger’s side,
from STEP 29.
STEP 37: This is the view of the upper pocket,
that needs to be removed.
The mark lines follow the bottom, using this edge as
a guide.