Filter
Top Products
The P81 and P941 require special care
a
nd handling during unpacking. Pay
p
articular attention to the precautions
that appear in this section and to other
precautions that appear throughout this
owner’s manual.
W
hen unpacking, save all packing
materials for possible future shipping
needs. Refer to the Obtaining Service
section on page 14 for additional
i
nformation.
Figure 1: Unpacking the P81/P941
To Unpack the P81 and P941:
1. Place the packing carton in the
upright position and fully open the top
flaps, as shown in Step 1 of Figure 1.
2. Without allowing the top flaps to
close, move the outer packing carton
into an inverted position, as shown in
Step 2 of Figure 1.
3. Lift the packing carton off of the
loudspeaker, as shown in Step 3
of Figure 1. Use caution to avoid
damaging the loudspeaker or frame
clamps. At this point, the loudspeaker
will be upside-down.
4. Remove the bottom pad, and then
remove the frame alignment tool
and grille from the grille filler
. These
items are identified in Figure 2.
5. Set aside the wall template, paint
mask, fiberglass insulation, spacer
shim, replacement scrim cloth and
Allen keys.
6. Invert speaker so it is in the upright
position.
7.
When the P81/P941 is in the upright
position, remove the top pad.
8. Leave the loudspeaker upright in the
bottom pad until ready to install.
5
U
NPACKING
Top Pad
Bottom Pad
Frame
Alignment Tool
Paint Mask
Protective
Cloth
Grille
Allen Keys/Spacer Shim
Fiberglass
Insulation
Wall Template
Replacement
Scrim Cloth
Figure 2: Packing Materials
Figure 2: Packing Materials
F
igure 1: Unpacking the P81/P941
¡
™
£
P81, P941 OM 2/18/05 10:55 AM Page 5