Filter
Top Products
WorkingwithReValver®MKIII
Thetlemodule
At the top of the graphical interface of the program is a module containing general setup
funconal ity, including the Inputvolume+-16dBadjustment(with pre and post LED indica tors),
Outputvolume-32dBadjustment (with post LED indicator). The adjustment knobs can automa-
cally adjust the input and output volume to 0dB by pressing the “Learn” buons.
Pressing the gearwheel icon brings up the Opons window.
The Title module also hosts the bank&preset management; see below.
Presetsandbanks
A preset of ReValver MK III is constructed from one or more sub-modules. The signalpath moves
down the path of modules from top to boom. If the “signal splier” has been inserted, the
chain is split into two parallel chains unl they are merged in the “signal merge module.”
There is no restricon on how to combine modules, as they can be “chained” in any combinaon
(although some combinaons are undesirable). The idea is to imitate the behavior and applica-
on of real-life amps and eect units.
Normally you would nd combinaonswiththisorder: Stompbox (if any), Amp, Speaker and
Eect (if any). An amp consists of a preamp and a power amp, and you may replace a module in
the “Amp” category with a combinaon of a “Preamp” and “Power Amp.”
Presetsareorganizedin“banks.” To select a preset from a bank, that bank must rst be selected
from the tle module at the top of the chain. A bank and preset can also be selected through MIDI
command.
To save a preset or bank in a new posion, press “New” beside the drop-down menu. You will be
asked to name it. When you have entered a name, press the “Done” buon or the Enter key. To
cancel, press the Escape key.
Aer you rename a preset or a bank, ReValver automacally saves it.
Pressing “Save” will save the current preset or bank into the currently selected posion, overwrit-
ing the old.
To import or export a preset or a whole bank, press the “Imp.” (import) or “Exp.” (export) but-
tons.
8