Filter
Top Products
5
Insignia NS-R5101AHD-A AV Home Theater Receiver
www.insigniaproducts.com
Top panel - NS-RB1
Back panel - NS-RB1
Setting up your home
theater system
Finding a location for your home theater
system
• Install your home theater system on a stable flat
surface. Position your receiver so that it has a
direct line of sight to the remote control.
• Do not expose your system to extremes of
temperature or humidity.
• Avoid placing your system on a hot surface such
as on top of other hot running equipment. Make
sure that there is adequate ventilation to your
system.
13 CH +/– buttons
ALBUM
In tuner mode, press to go to the next or
previous preset channel.
14 RETURN button In menu mode, press to return to the main
menu or previous menu.
15 AUDIO button Press to access audio settings. See
“Changing audio settings” on page 26.
16 Number buttons Press to enter a preset number or to
manually tune the radio.
17 SLEEP/CLR button Press repeatedly to select the sleep timer
duration.
In menu mode, press to clear an entry.
# Description Function
1 Power/Join button Press to turn the device on, then hold to initiate
joining. Press again to go to standby.
2 Power/Join indicator Lights blue when HUB STATUS is set to DISABLE.
Lights green when HUB STATUS is set to ENABLE.
Lights steady when the sender/receiver is joined to
a network.
Blinks slowly when the sender/receiver is not
joined to a network.
Blinks quickly when the sender/receiver is in
joining mode.
3 Standby indicator Lights red when the sender/receiver is in standby
mode.
4 Subwoofer - Sender mode
indicator
Lights blue when the sender setup for subwoofer
is ON.
5 Surround - Sender mode
indicator
Lights blue when the sender setup for surround is
ON.
6 Stereo - Sender mode
indicator
Lights blue when the sender setup for Zone 2 is
ON.
7 Source button Press to move to the next receiving source. Each
press toggles to the next source.
8 Rx - Receiver mode indicator Lights blue when receiving signals.
Item Description Function
ON/STANDBY
STANDBY SUBWOOFER STEREO
SOURCE
SURROUND
13 4
5
6782
# Description Function
1 External antenna Receives signals from other Rocketboost™ senders.
Sends signals to other Rocketboost
™ receivers.
2 HUB STATUS switch Enables/disables hub mode operation. See
“Establishing communications” on page 13 for
additional information.
When hub status is enabled, the device is on even
when the receiver is in standby mode.
When hub status is disabled, the device is off when
the receiver is in standby mode.
Note: In a Rocketboost™ network, only one
Rocketboost™ device should have the Hub Status
switch set to ENABLE.
3 Subwoofer IN jack Connect to the Subwoofer Preout jack using a
mono RCA cable (not provided).
4 NS-RB1 cable Connect to the Rocketboost™ port on the receiver.
The receiver supplies power, surround L/R,
subwoofer, and Zone2 signals. The device supplies
received signals from other Rocketboost
™ senders.
Caution
Do not install the receiver in a confined space such as
a bookcase.
Caution
Connect the AC cord only after the speakers,
antenna, and all optional equipment have been
connected. Never make or change any
connections with the power turned on.
DISABLE ENABLE
IN
HUB STATUS SUBWOOFER
4
1132
NS-R5101AHD-A_10-0487_MAN_.book Page 5 Friday, May 7, 2010 7:51 AM