Filter
Top Products
14
Insignia NS-R5101AHD-A AV Home Theater Receiver
www.insigniaproducts.com
To install the batteries:
1 Remove the cover.
2 Insert two AA batteries into the compartment
matching the polarity indicated.
3 Replace the cover.
Using the remote control
Use the remote control by pointing it towards the
receiver’s remote sensor window. Objects between
the remote control and sensor window may
prevent proper operation.
Use the remote control within about 16 feet
(5 meters) of the receiver and within 30 degrees of
perpendicular to the front of the receiver.
Using the Audyssey 2EQ® room correction
and speaker setup
With the supplied calibration microphone,
Audyssey 2EQ® automatically determines the
number of speakers connected, their size (for
purposes of bass management), optimum
crossover frequencies to the subwoofer (if present),
and distances from the primary listening position.
Audyssey 2EQ then removes the distortion caused
by room acoustics by capturing room acoustical
problems over the listening area in both the
frequency and time domain. The result is clear,
well-balanced sound for everyone.
Enabling Audyssey 2EQ lets you also use Audyssey
Dynamic EQ®, which maintains the proper
octave-to-octave balance at any volume level.
Before using this function, connect and position all
of your speakers.
It takes about 15 minutes to complete the room
correction and speaker setup for three positions.
Total measurement time varies depending on the
number of speakers.
Using Audyssey 2EQ®
To create a listening environment in your home
theater that all listeners can enjoy, Audyssey 2EQ®
takes measurements at up to three positions within
the listening area.
Position the microphone at ear height of a seated
listener with the microphone tip pointed directly at
the ceiling using a tripod. Do not hold the
microphone in your hand during measurements as
this produces inaccurate results.
First measurement position (1)–Also referred to
as the Main Listening Position this refers to the
most central position where one would normally sit
within the listening environment. 2EQ uses the
measurements from this position to calculate
speaker distance, level, polarity, and the optimum
crossover value for the subwoofer.
Second measurement position (2)–The right side
of the listening area.
Third measurement position (3)–The left side of
the listening area.
The distances from position 1 to 2 and 1 to 3 must
be at least 3.3 feet (1 meter).
Cautions
• Do not expose the remote control to shock. In
addition, do not expose the remote control to
liquids, and do not place in an area with high
humidity.
• Do not place the remote control under direct
sunlight. The heat may cause deformation of
the remote control.
• The remote control may not work properly if the
remote sensor window of the receiver is under
direct sunlight or strong lighting. In such a case,
change the angle of the lighting or receiver, or
operate the remote control closer to the remote
sensor window.
Batteries (AA/R6)
Approx. 16 ft. (5 m)
Receiver
Remote control sensor
TV
NS-R5101AHD-A_10-0487_MAN_.book Page 14 Friday, May 7, 2010 7:51 AM