Filter
Top Products
Copyright ©2005 by ILY Enterprise Inc.
All Rights Reserved.
28
System will search the new firmware from the
CD and the LCD will show the process as left.
When find the new firmware, just press “ENT”
button. The system will update it.
4.12.8 Compare Firmware
This function will help you compare your current control firmware version and the updated version
in your firmware disc that you insert into the CD-ROM.
Press “ENT” button to enter “Compare Firmware”
and “ESC” to exit.
.
4.12.9 H/W Diagnostic
This function will detect which types of devices are connected with the control. The LCD will show
the hardware information.
Press the ENT button to enter “H/W Diagnostic”
and “ESC” to exit.
LCD will ask user to do the button test. Following
the LCD instruction test each function button.
After the button function testing, the system will self-test SDRAM, the hardware connecting test,
and flash test. Every testing process will be shown on the LCD. It just takes a few minutes to get
the results of hardware diagnostics. It is an easy way to know if the system works properly.
When testing is finished, the LCD will show the
“Test finished” message. Press “ESC” button to
go back 12-09 menu.
4.12.10 Load Default
This function will reset whole previous setting back to factory’s default setting. Different settings
will cause duplicator to react differently.
Press “ENT” button to enter “Load Default” and
“ESC” to exit.
Use the arrow button to change settings. When
“Yes” is selected, the duplicator will return to
factory’s default setting.
The LCD message will show that the setting has
been changed by with the follow message:
Searching F/W---
XXX/XXXXX
12-08. Adv Setup
Compare Firmware
12-09. Adv Setup
H/W Diagnostic
Enter ESC
Hold ESC to exit
Test finished
12-10. Adv Setup
Load Default
Load Default
Config? Yes
Load Default
OK