Filter
Top Products
Copyright ©2005 by ILY Enterprise Inc.
All Rights Reserved.
10
• When a Copy completes, the passed (correctly copied) CD discs will be ejected
automatically. The default is to eject automatically, but this can be changed.
• Failed discs will remain in writers. The default setting is keeping failed discs in the writers,
but this can be changed. Press the buttons on the drivers to take the failed CDs.
• During operation do not press any button, interruption will harm the device. CDs will be
damaged.
2. Without a hard drive installed
If you don’t install a 3.5” hard disc, the operation procedures will be as follows:
• Insert the master disc to CD-ROM.
• Switch to the Copy function by pressing arrow button. Insert blank CD-R or CDRW disc
into all the CD writers. Press “ENT” button to start.
• When Copy completes, the passed CDs will eject automatically. The default is to eject
automatically, but this can be changed.
•
Failed CDs will remain in the writers. The default setting is that failed CDs stay in the
writers, but you can change the setting. You need to press the “eject” buttons on the
writers to take the failed CDs.
ATA-66 Cable Layout:
Please identify two different kinds of cable before the hardware installation.
Chapter 4 Function
4.1 Copy
Use this function to copy data from a source CD directly onto blank CD discs. Before copying
make sure that the source CD is insertd into CD-ROM. If you have a HDD, make sure there is
data in your HDD partition. If you are not sure about the success of your duplication job, you can
use function 2, Test, to simulate the copying process first.
Select function 1. Put a source CD into CD-ROM and blank CD disks into CD writers. CD
rewriteable discs containing old data are usable, too.
LCD will show the process of copying
information as follows:
When copying is completed, the LCD will display as
the following information:
Discs correctly copied will be ejected automatically
Copying-24X 0%
650.0MB 74:00
1
.
Copy
OK: 03
3
.
Test & Copy
OK: 03