Filter
Top Products
14
Alarm Operation
The iH26 Home System features “Sure Alarm”. If a power failure occurs or the AC cord is accidentally disconnected,
the unit will change to Buzzer alarm to wake you up (provided you have installed back up batteries).
This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set.
NOTE: TO WAKE TO iPOD
®
, YOUR iPOD
®
MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY
MODE) OR NO ALARM WILL SOUND.
1. Set the alarm time per Setting Alarm time. To preview the alarm time, just press the ᕨ Alarm Set Button once.
2. You can change the sound mode you wish to wake to at any time by pressing the Wake-To Button.
3. Press the ᕨ Alarm On/Off Button to arm or disarm the alarm.
4. When the alarm is sounding, press the ᕣ Power Off/Alarm Reset Button on the iH26 (or
ƻ Power On/Off
Button on the remote control) to turn the alarm OFF. The alarm will come on again the next day at the same
time.
5. To stop the alarm from coming on the following day, press the ᕨ Alarm On/Off Button to turn it OFF. The
Alarm Icon and Wake Icon will disappear to indicate the alarm is disarmed.
6. If the alarm is not turned off after it sounds it will play for approximately 1 hour then turn off automatically.
This cycle will repeat every 24 hours unless the controls are changed.
Note: When you select Wake To iPod
®
, please make sure your iPod
®
has enough songs to play for 1 hour,
otherwise please set the iPod
®
repeat mode to ON.
Note: If you select Wake To iPod
®
but no iPod
®
is present or there is no music on the iPod
®
at alarm time, the
iH26 will automatically switch to buzzer alarm.