Filter
Top Products
10
Using The Remote Control Unit
Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control
stops operating or its range seems reduced, replace the battery with a new one.
1. The battery door is located on the back end of the unit.
2. Squeeze notched tab A while pulling battery door latch B to release the battery door
latch and take out the battery holder.
3. Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and – side of the
battery) is correct.
4. Replace the battery holder back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
The Remote Control controls basic functions on the iH26 and certain iPod
®
functions when the iPod
®
is docked in the iH26.
For beslt results, aim remote control towards the lower right corner of the display.
Sleep Button
ƺ iPod Play/Pause Button
ƻ Alarm Reset/
Power Off Button
ƽ Button
Ƽ Button
Mute Button
Snooze/Dimmer Button
ƾ Volume+ Button
ƿ Volume
_
Button
Battery
door
latch
Turns iH26 ON or OFF or reset alarm when alarm is sounding
Selects iPod and plays track. In play mode, press to pause
Selects AM or FM radio band
Selects Sleep function
Snooze mode when alarm sounds, otherwise dims display
Lowers volume level
Raises volume level
Skip to previous or next track when iPod is playing, or
HOLD to scan current playing track. In radio mode, press
to tune statitions. HOLD to scan radio stations.
B
A