Icom IC PCR100 Stereo Receiver User Manual


 
34
6
BAND SCOPE
Operation
The band scope function allows you to visually check a spec-
ied frequency range.
Receive audio is muted while monitoring the band scope.
Push [s/❙❙] to pause sweeping and receive the audio.
DUsing the multi-function receiver screen
q Click the sweep start/pause button ([s/❙❙]) to begin a
sweep; signal conditions appear starting from the center of
the range.
Conditions over the entire set frequency span can be observed
around the center frequency of the currently received frequency.
w Click the [SPAN+] or [SPAN] button to select the sweep
width through SPAN1 (±100 kHz) to SPAN4 (±2 MHz).
e Click the [TSJ] or [TSK] button to select the sweep tuning
step.
•“LIMITappears when a tuning step greater than the sweep step
range is selected.
r Click the waveform to select the frequency of the signal.
Click the [s/❙❙] button to pause a sweep and monitor the fre-
quency.Repeat to resume the sweep.
While pausing the band scope, you can also select the frequency
by clicking the waveform. The current receive frequency is
marked by a dotted line and the previous receive frequency is
displayed at center.
t Click the sweep stop button ([]) to cancel a sweep.
DUsing the simple function receiver screen
q Call up the band scope screen if it is not displayed.
Click the [MENU] button and select the Band Scope.
w Click the sweep start/pause button ([s/❙❙]) to begin a
sweep; signal conditions appear starting from the center of
the range.
Conditions over the entire set frequency span can be observed
around the center frequency of the currently received frequency.
e Click the [] or [] button to select the sweep width
through SPAN1 (±100 kHz) to SPAN4 (±2 MHz).
Choose [SPAN1] when band conditions are crowded (many sig-
nals are present); choose [SPAN4] when few signals are present.
r Click the [TSJ] or [TSK] button on the function controller
screen to select the sweep tuning step.
Click [MENU] and select the Function controllerwhen it is not
displayed.
•“LIMITappears when a tuning step greater than the sweep step
range is selected.
Click to select sweep width.
Click to start or pause sweeping.