Filter
Top Products
27
5
SCAN OPERATION
■ Programmed scan
Programmed scan automatically searches for signals within
a specified frequency range.
For programmed scan, scan edges must be programmed
in advance. See the next section for details.
DUsing the multi-function receiver screen
q Make sure the squelch is set to the threshold point. (closed
condition)
w Click the [SET] button to call up the setting screen if it is
not displayed.
e Click the [Program SCAN] tab to show the program list.
r Select a programmed scan range to be scanned with the
mouse, then click the close (["]) button.
t Click the [PROG] button to start programmed scan.
•“PROG”flashes while scanning.
y To cancel the scan, click [STOP] or [PROG].
•When the frequency is changed after cancelling a scan and a
new scan is activated, scan starts from the starting frequency of
the specified frequency range. When the frequency is not
changed, scan starts from the previously stopped frequency.
DUsing the simple function receiver screen
q Make sure the squelch is set to the threshold point. (closed
condition)
w Call up the setting screen if it is not displayed.
•Click the [MENU] button and select the ‘Function Setting (SET).’
•When the scan controller screen is in use, click the [SET] button
on the screen.
e Click the [Program SCAN] tab to show the program list.
r Select a programmed scan range to be scanned with the
mouse, then click the close (["]) button.
t Call up the scan controller screen if it is not displayed.
•Click the [MENU] button and select the ‘Scan Controller.’
y Click the [PROG] button in the scan controller screen to
start programmed scan.
•“Program SCAN” flashes in the scan controller screen while
scanning.
u To cancel the scan, click [STOP] or [PROG].
•When the frequency is changed after cancelling a scan and a
new scan is activated, scan starts from the starting frequency of
the specified frequency range. When the frequency is not
changed, scan starts from the previously stopped frequency.
[PROG]
[STOP]
[SET]