Filter
Top Products
Getting Started (Controls) ::- ,-
DISPLAY Used in on-screen programming and indexing.
CLEAR Used in on-screen programming and indexing.
VCR/TV Switches between viewing through the VCR and not viewing through
the VCR.
VOLUME Increase or decrease the audio volume.
PROGRAM Used to program the timer for unattended recording.
REW Rewinds the videotape.
PLAY Starts playing a loaded videocassette.
REC Starts recording on the station the VCR is set to.
VCR, TV, CATV (MODE SELECT) Device buttons let you set the remote to
control one of the three devices.
0 to 9 Number buttons used in on-screen programming. Can also be used to
change channels. (Simply press 2 or 3 digits for the channel you want--such as 0
and 6 for channel 6, or 100/ENT and 2 and 4 for channel 124.)
AVX Used for recording from an auxiliary input such as a stereo system.
CHANNEL Top button switches to the next higher channel, bottom button
switches to the next lower channel. For these to operate, you must have preset
your channels.
LAST CHANNEL Switches to the TV channel you watched previously during the
current viewing session.
F.FWD Fast forwards the videotape.
STOP Stops a videocassette from playing, recording, pausing, rewinding--or
anything it is doing.
PAUSE Temporarily stops the cassette from recording or playing. Press PAUSE
again (or PLAY) to resume.
When the Remote Doesn't Work Right
Check out these possibilities:
Low Battery
If the remote is not working even at close range, try putting in two fresh AA
batteries.
When replacing the batteries, remove the old batteries and press the POWER
button on the remote and hold it for about 10 seconds, then insert two fresh
batteries.
Objects in the Way
]7