Filter
Top Products
-E35-
PHONES
POWER/STANDBY
FM MODE VOLUME
f /TUNE - e /TUNE + d /PRESET c /MEMO
SURROUND BASS SOUND SOURCE
k
an
q
OPEN/
CLOSE
2, 43
TIMER ADJUST SET/CLEAR
CLOCK
VOLUME
TEST TONE
FUNCTION
FM MODEPRESET
SOUNDBASSSURROUND
+-MUTE
TU/BAND
0
+10
3
PHONES
POWER/STANDBY
FM MODE VOLUME
f /TUNE - e /TUNE + d /PRESET c /MEMO
SURROUND BASS SOUND SOURCE
k
an
q
OPEN/
CLOSE
12
PROG.
MHz
PROG.
MHz
MHz
TEST TONE
SOURCE
FM MODEPRESET
SOUNDBASSSURROUND
MUTE
TU/BAND
0
879
+10
546
213
ANGLE A.REPLAY ZOOM
AUDIO
SLEEP
TIMER ADJUST SET/CLEAR
CLOCK
VOLUME
2
1
Number
buttons
TU/BAND
FM MODE VOLUME
f /TUNE - e /TUNE + d /PRESET c /MEMO
SURROUND BASS SOUND SOURCE
k
an
q
OPEN/
CLOSE
FM MODE
DV-RM522
TEST TONE
SOURCE
FM MODEPRESET
SOUNDBASSSURROUND
MUTE
TU/BAND
VOLUME
FM MODE
Manual presetting
1. Tune in the station to be preset as described in “Automatic/
Manual Tuning”.
2. Press [c/MEMO].
“PROG.” blinks.
3. While “PROG.” is blinking, press [d/PRESET] (or [PRESET]
on the remote control) to select the channel to be preset.
• In this example, the channel is “9”.
4. While “PROG.” is blinking, press [c/MEMO].
• In this example, “103.1 MHz” FM station is preset on FM
channel 9.
5. Repeat steps above to add more preset stations.
• When presetting a new station, the previous preset station is
cleared.
Listening to Preset Stations
1. Press [SOURCE] (or [TU/BAND] on the remote control) to
select FM or AM.
2. Press [d/PRESET] (or [PRESET] on the remote control)
briefly to select the desired channel.
• The number buttons on the remote control can also be
used.
Example: To select No.9, press [0], then [9].
Note: No not press the [+10] button.
Preset scan tuning
1. Press [SOURCE] (or [TU/BAND] on the remote control) to
select FM or AM.
2. Press [d/PRESET] (or [PRESET] on the remote control)
for at least 1 second.
• The channel number appears.
• The preset stations are selected in sequence for
approximately five seconds each.
3. Press [d/PRESET] (or [PRESET] on the remote control)
when the desired station has been selected. Preset scanning
will stop.
To receive FM stereo broadcasts
Make sure that “MONO” is not displayed. If “MONO” appears,
press [FM MODE] to turn the “MONO” indication off.
“ST” appears when an FM stereo broadcast is received.
• If the signal from an FM stereo station is weak and reception
is poor, press [FM MODE] to change to monaural reception.
The reception may be improved, but the sound will be
monaural.