Filter
Top Products
Appendix A Troubleshooting and
Maintenance
A-3
A
Mini Controller Reset
The Mini Controller may be reset two different ways:
•press the <
program
>, <
intensity
>, <
rate
>, and <
audio
> keys simultaneously
• turn the configuration DIP switch to the Off position and return it to the On position
Note: when the Mini Controller is reset, all default values will be in effect and Standby Mode
will be engaged.
Mini Controller ROM Version Number
To view the ROM version number, turn the Configuration Dip switch to the Off
position and press any key. The ROM version number will appear on the display.
General Maintenance and Cleaning
You should clean your Mini Controller on a regular basis. Dust and dirt can
accumulate and cause malfunctions. As a precautionary step, unplug the Mini
Controller before cleaning. To clean the outer surfaces:
• Wipe with a soft cloth or tissue, or use a small vacuum to remove the built-up dust and
dirt. Do not use a blower, as this will force dirt into the controller.
Warnings: Do not submerse in liquid. There are no user serviceable parts inside. Servicing
should only be conducted by a qualified technician.
Audio indicator does not
light up
weak or no audio signal check to ensure cable is
properly connected, boost
audio signal (between 20
Hz to 100 Hz)
Audio indicator does not
light up
bad audio cable check the tip, ring, and
sleeve resistance with a
Volt Ohm meter–replace
or repair cable
Audio indicator does not
light up
a speaker level signal has
been sent to the audio
connector
contact High End Systems
Technical Support
Audio indicator
constantly stays on
audio signal is too strong reduce audio signal
Table A.1: Trouble Shooting Solutions
Problem Probable Cause Solution