Filter
Top Products
Chapter 1 Installation and Setup
1-3
1
Next, each strobe must be set for two channel DMX mode. This is accomplished
by setting Personality switches <
3
> and <
4
> to the On position (switch <
5
> must
be in the off position).
Finally, set the fixture address switches to 1–23 (depending upon how many
fixtures you have). Refer to Table 1.2 for the appropriate settings.
Notes: if a DMX channel is accidentally set for an even channel number, the
Intensity and Rate functions will be reversed causing the strobe to behave
erratically. The Mini Controller can control more than twelve strobes, but
additional AF1000 strobes must be set at duplicate addresses with other
existing strobes.
Table 1.2: DMX Address Switch Setting
Fixture
Number
DMX
Channel
Address
Switches
On
1 1 none
232
353
4 7 2, 3
594
6112, 4
7133, 4
8 15 2, 3, 4
9175
10 19 2, 5
11 21 3, 5
12 23 2, 3, 5