Filter
Top Products
Introduction
Intro-5
1. <
STANDBY
> disables controller output of programs
2. <
flash
> when held down, causes all connected
strobes to flash at full intensity for .15
seconds at 50 Hz. and .125 seconds at 60
Hz.
3. Up/down arrow keys increments values up/down
4. <
program
> provides access to current program,
Program Advance Mode, and Program
Hold Mode
5. <
rate
> provides access to the Rate parameters
6. <
intensity
> provides access to the Intensity
parameters
7. <
audio
> provides access to the audio parameters
8. Value display displays the current value or mode via
two 7-segment LEDs
9. Program hold indicator LED when lit, Program Hold Mode is in use
10. Audio beat indicator LED indicates that an audio signal is present,
the rate of the beat, and the strength of
the audio signal
11. Output channel display LEDs indicates the intensity and operation of
the applicable channels
12. Configuration DIP switches selects the number of output channels
13. Data Link Out 3-pin female XLR connector that
provides serial DMX data to the
strobes
14. Audio Input 1/4-inch stereo input jack
15. Line cord Mini Controller AC power cable