Filter
Top Products
(4) Setting the contrast of the LCD screen under normal conditions
Set the contrast of the LCD screen under normal conditions.
→ [Rotary key] or [F1 or F2] to select the item whose value is to be changed →
[ENTER] to enter the selection
→ [Rotary key] or [F1 or F2] to change the value → [ENTER] to enter the selection
Align the cursor with CONTRAST, and adjust the value. It can be changed to any value
from -50 to +50.
7.3 CONFIG SETUP
The VA-1809's unit settings are established using CONFIG SETUP.
TOP → SETUP MENU[SETUP] → CONFIG SETUP[F2]
The menu is configured as shown below.
SETUP
HOTPLUG button execution mode
△△
P.
Program Group Mode
Program Mode
A
NALYSIS
F2
Volume setting
HOTPLUG button execution mode
Trigger settings for log execution
VA-1809 unit settings
△△
P.
△△
P.
A
uto Mode
Manual ModeHotPlug Mode
Speaker Volume
△△
P.
HDCP
A
udio
Channel Status Bit
MPEG InfoFrame
A
udio InfoFrame
SPD InfoFrame
A
VI InfoFrame
Video Timing
A
LL
A
nalysis Trigge
r
CONFIG SETUP
7.3.1 Setting the trigger for log execution
→ [F1 or F2] to select trigger item of ANALYSIS TRIGGER →
[ENTER] to enter selection or ??selection-to-be??
Set the trigger for capturing the log for log execution.
Align the cursor with the trigger for setting ANALYSIS TRIGGER, and change
the ON/OFF status of the check button.
25