Filter
Top Products
* To execute group data, the execution mode must be set to PROGRAM GROUP
MODE. Refer to page ???.
* When executing group data, refer to ??? on page ???.
7.1.2 Executing the program data (LOAD)
Execute the program data or group data created by following ??? on page ???.
* Either the program data is selected directly or the data in the groups is selected
depending on the execution mode established by the VA-1809's settings. For
the execution mode settings, refer to ??? on page ???.
One method of executing the program data is to select ANALYZE EXE using the
ANALYZE button from TOP, and another method is to select PROGRAM EXE
using the PROGRAM button from TOP.
7.1.2.1 Executing the data from ANALYZE EXE
TOP
ERROR
REPORT
DIRECT NUM
INC
DEC
DETAILS
ANALYZE
F1
F2
F3
F4
The program data can be ???executed??? during measurement by executing it
from ANALYZE EXE.
TOP → ANALYZE EXE [ANALYZE]
(1) Using INC and DEC to execute the program data
INC[F2] or DEC[F3]
INC is used to execute the data in the program whose number follows the number
of the current program whereas DEC is used to execute the data in the program
whose number precedes the number of the current program.
(2) Using DIRECT NUM to execute the program data
DIRECT NUM [F4] → [Rotary key] to select program data to be executed →
[ENTER] to execute the data
----------------------------------リスト表示---------------------------------------
From the list, select the program data to be executed, and execute it.
22