Filter
Top Products
7. Detailed setup
7.1 HDMI equipment performance settings
The performance of the HDMI receiver is stored in the EDID and HDCP registers and
relayed when the data is read by the HDMI transmitter. By rewriting this data in the
VA-1809, various kinds of monitors can be simulated.
The data can be registered as a program and stored on a CF card or as an internal pattern.
This section describes the procedures from creating to executing the program data.
7.1.1 Creating the program data
The program data creation screen is displayed when the PROGRAM button is
pressed from TOP. The menu tree is as shown below.
PROGRAM
TOP
F2
F1F3
F2
F1
SINK Edit
EDID EditProgram Edit
Program editing
List Edit
COPY
PROGRAM
EXE
Program copying
Group setting
EDID editing
SINK editing
7.1.1.1 Copying the program data
The procedure for creating the program data using existing program data is set
forth below.
TOP → PROGRAMEXE[PROGRAM] → COPY[F1]
(1) Selecting the program data to serve as the basis for editing
[Rotary key] to move the cursor → [ENTER] to enter the selection
Move the cursor using the [Rotary key], and select the program data which will
serve as the basis for editing. To enter the data, press ENTER.
---------------------ソース選択画面を挿入---------------------------------
19