Filter
Top Products
Initial Configuration 123
Initial Configuration
Initial Startup
After you have connected the equipment, you are ready
to turn on the system.
1 Make sure the video and audio cables are
connected before you turn on the TV and the
HP Digital Entertainment Center.
2 Turn on all connected system equipment, such as TVs,
set-top boxes, and AV receivers.
3 Plug the HP Digital Entertainment Center AC power
cable into a wall outlet.
Use a surge protector to prevent power surges or
voltage spikes.
4 Press the On/Standby (power) button on the front
of the HP Digital Entertainment Center. The system
starts.
5 See “Syncing the Keyboard” on page 124.
The display on the TV screen may not be optimized until
after you set the display settings.
n
Set the volume to mid-level on the AV receiver
and on the TV.
DIGITAL VIDEO OUT
DVI
DIGITAL
AUDIO
OUT
COAXIAL
OPTICAL
10/ 100/ 1000
HI SPEED USB 2.0 ETHERNET1394
AUDIO IN
R
L
AUDIO 7.1 PRE-OUT
SURROUND
BACK
SURROUND CENTER
SUB
WOOFER
FRONT
R R R
L L L
VIDEO OUT
S-VIDEO COMPONENT
VIDEO
Y
Pb
VGA
Pr
INFRARED TRANSMITTER OUT
12
TV SOURCE 1 IN
VIDEO
AUDIO
S-VIDEO
R
L
WIRELESS LAN 802.11 b/g
REMOVABLE ANTENNA
ACTIVITY
LINK
TV ANTENNA INFM ANTENNA IN
AC IN
100-240V- 4/A 50/60Hz
TV SOURCE 2 IN
S-VIDEOAUDIO
RL
75Ω
COAXIAL
DUAL
TUNER
AC IN
110-240V 50-60Hz
Wall
Outlet
Surge Protector
Line Conditioner
Do Not Remove
w
Make sure you have followed all safety
instructions for your HP Digital Entertainment
Center, especially the important AC power
information.
See “Safety Information” on page 19.
Power On
On/Standby