Filter
Top Products
ENGLISH
15
Connecting the antennas
1 Plug the cable of the rooftop antenna into the FM antenna
socket »FM 75Ω«.
Note:
If no rooftop antenna is available, use the auxiliary antenna
supplied. This antenna provides reasonably good reception of
local FM (VHF) stations. Do not shorten the auxiliary antenna.
2 For medium wave reception, plug the cable of the supplied MW
frame antenna into the »AM LOOP« socket.
Note:
In order to prevent interference, place the MW frame antenna
as far as possible from the home cinema system or other
sources of interference.
Connecting the power cord
1 Plug the power cord (»~AC IN«) into the wall socket.
Note:
If the DVD receiver does not react when the buttons are
pressed, this may be caused by electrostatic discharge in the
area. In this case pull out the mains plug and insert it into the
socket again after a few seconds.
Inserting batteries in the remote control
1 Open the battery compartment by pressing the marked area
and pulling down the cover.
2 When inserting the batteries (2 x 1.5 V, LR 06/UM 3/AA),
observe the polarity marked on the battery compartment.
3 Close the battery compartment.
Note:
If the DVD receiver no longer reacts properly to remote control
commands, the batteries may be flat. Be sure to remove used
batteries. The manufacturer accepts no liability for damage
resulting from leaking batteries.
Environmental note:
Batteries, including those which contain no heavy metal, may
not be disposed of with household waste. Please dispose of
used batteries in an environmentally sound manner. Find out
about the legal regulations which apply in your area.
CONNECTION AND PREPARATION_________
SCART
FM 75Ω
S-VIDEO
AM
LOOP
RESET
TVR
SCART
FM 75Ω
S-VIDEO
AM
LOOP
RESET
A
M
L
O
O
P
A
N
T
E
N
N
A
~AC IN
SPEAKER
SW C RS LS R
8-16Ω4-8Ω
IMPEDANCE