Filter
Top Products
Appendix 53
DSP5000C User Guide
Type 2 setup, Meridian CD as preamp (via 607), 204
connected
The Meridian compact disc player range includes players with built-in
preamplifiers, such as the 207 and the 208. To use the analogue inputs of
these units, it is necessary to put a 607 (or similar) A/D converter between
the fixed output of the preamp section and the D2 input of the DSP5000C.
It is possible to control one of the previously mentioned CD preamp
combinations and a Meridian FM tuner using Type 1. Type 1 sets the
DSP5000C as a left master, so you will need to make the other a right
slave, or adjust left/right on both speakers.
Type 2 200 208, 207
Remote key Logo Input on
DSP5000C
Control? Input on CD
Preamp
CD cd D1 1C CD
Radio rd D2 2C Line
LP LP D2 NC LP
Tape 1 t1 D2 NC Tape
Video N D2 NC No change
Tape 2 N D2 NC No change
Type 3 setup, 601, 201, 603 or 562 as preamp via 607,
Meridian CD and 204 connected
In this Type, all sources are mediated through an external control unit or
preamplifier. The output of an analogue preamplifier (201 or 603) will have
to be converted to a digital signal for DSP5000C. A Meridian 607
converter is recommended.
The Meridian 601 preamplifier incorporates an analogue–to–digital
converter for analogue sources. The 601 has very comprehensive
customisation facilities, and these are covered in its manual. If you are
using DSP5000C with a 601, you are advised to study the 601 user guide,
bearing in mind that recommendations concerning D6000 apply equally to
DSP5000C.
It does not make sense to connect a Meridian CD player to an analogue-
only preamplifier such as the 201 or 603. For such a connection you
should use Type 4.
Type 3 200 201, 601, 603
Remote key Logo Input on
DSP5000C
Control? Input on
Preamp
CD cd D1 1C CD
Radio rd D1 2C Radio
LP LP D1 NC LP
Tape 1 t1 D1 NC Tape 1
Video tn D1 NC Video
Tape 2 t2 D1 NC Tape 2